Search the data

Metadata Report for BODC Series Reference Number 530098


Metadata Summary

Data Description

Data Category Offshore sea floor pressure series
Instrument Type Bottom pressure sensor tide gauge
Instrument Mounting fixed benthic node
Originating Country United Kingdom
Originator -
Originating Organization Proudman Oceanographic Laboratory (now National Oceanography Centre, Liverpool)
Processing Status banked
Online delivery of data Download available - Ocean Data View (ODV) format
Project(s) WOCE
ACCLAIM
 

Data Identifiers

Originator's Identifier DPNNS956.I4D
BODC Series Reference 530098
 

Time Co-ordinates(UT)

Start Time (yyyy-mm-dd hh:mm) 1995-11-26 05:52
End Time (yyyy-mm-dd hh:mm) 1996-11-17 11:37
Nominal Cycle Interval 900.0 seconds
 

Spatial Co-ordinates

Latitude 56.83580 S ( 56° 50.1' S )
Longitude 57.50150 W ( 57° 30.1' W )
Positional Uncertainty Greater than 10 n.miles
Minimum Sensor or Sampling Depth 2095.0 m
Maximum Sensor or Sampling Depth 2095.0 m
Minimum Sensor or Sampling Height 1.0 m
Maximum Sensor or Sampling Height 1.0 m
Sea Floor Depth 2096.0 m
Sea Floor Depth Source -
Sensor or Sampling Distribution Fixed common depth - All sensors are grouped effectively at the same depth which is effectively fixed for the duration of the series
Sensor or Sampling Depth Datum Approximate - Depth is only approximate
Sea Floor Depth Datum Instantaneous - Depth measured below water line or instantaneous water body surface
 

Parameters

BODC CODERankUnitsTitle
AADYAA011DaysDate (time from 00:00 01/01/1760 to 00:00 UT on day)
AAFDZZ011DaysTime (time between 00:00 UT and timestamp)
PPSSPS011DecibarsPressure (measured variable) exerted by the water body by fixed in-situ pressure sensor and expressed to unspecified datum by subtraction of a constant
TEMPPR011Degrees CelsiusTemperature of the water body

Definition of Rank

  • Rank 1 is a one-dimensional parameter
  • Rank 2 is a two-dimensional parameter
  • Rank 0 is a one-dimensional parameter describing the second dimension of a two-dimensional parameter (e.g. bin depths for moored ADCP data)

Problem Reports

No Problem Report Found in the Database

Data Quality Report

Series depth was set nominally as one metre above sea floor.


Data Access Policy

Open Data

These data have no specific confidentiality restrictions for users. However, users must acknowledge data sources as it is not ethical to publish data without proper attribution. Any publication or other output resulting from usage of the data should include an acknowledgment.

If the Information Provider does not provide a specific attribution statement, or if you are using Information from several Information Providers and multiple attributions are not practical in your product or application, you may consider using the following:

"Contains public sector information licensed under the Open Government Licence v1.0."


Narrative Documents

No Narrative Document information held in the BODC database


Project Information

The ACCLAIM Programme in the South Atlantic and Southern Oceans

Introduction

The ACCLAIM (Antarctic Circumpolar Current Levels by Altimetry and Island Measurements) programme in the South Atlantic and Southern Oceans consists of measurements from coastal tide gauges and bottom pressure stations, together with an ongoing research programme in satellite altimetry. ACCLAIM is the Proudman Oceanographic Laboratory's main contribution to WOCE (and, in particular, to WOCE Core 2) and one of its objectives is the study of variations of the Antarctic Circumpolar Current. ACCLAIM is managed within the Global Sea Level Change (GSLC) group at POL led by Dr.J.M.Vassie.

The history of the development of ACCLAIM is described in the report by Spencer et al. (1993)

Phase 1

From Spencer et al. (1993) it can be seen that in Phase 1 of ACCLAIM from 1983, measurements at coastal tide gauge sites took the form of sub-surface pressure (SSP) measurements (units of pressure e.g. mbar) rather than sea level (units of length e.g. centimetres). SSP is here defined as the total, measured pressure recorded by a sub-surface pressure transducer, a measurement which includes the pressure load from the atmosphere as well as from the water column. It is absolutely essential that any user of ACCLAIM data realises which data type (either SSP or sea level) is being analysed.

The Phase 1 coastal SSP data were acquired in different ways (e.g. with a diver-replaced Aanderaa pressure gauge at Ascension, or with a Digiquartz in the sea sensor at St.Helena, see Spencer et al. 1993 for details) and with different pressure integration periods (e.g. quarter hour, half hour, one hour). For WOCE Centre purposes the original data have generally been filtered to give one hour sampling.

However, common to all records is an uncertainty connected with potential offset biases and drifts in the pressure sensors. At some sites (e.g. St.Helena) extensive tide pole data are also available and biases and long term drifts in the sensor data may eventually be rectified (this is under study at present). However, the drifts in general mean that in most cases the records should not be used, without further careful attention in particular studies, for the study of timescales seasonal or longer.

Phase 2

From around early 1993, the gauges at many of the sites were replaced by Phase 2 ACCLAIM 'B gauges' which record SSP, air pressure and sea level as described in Woodworth et al. (1996)

The Phase 2 coastal sea level data have precise datum control (see Woodworth et al. 1996 for details) and can certainly be used for long term studies. These data have also been contributed to the Permanent Service for Mean Sea Level (PSMSL) and Global Sea Level Observing System (GLOSS).

Ancilliary Data

Some of the Phase 1 data and all the Phase 2 coastal data will also contain ancillary information on air pressures and sea temperatures from ACCLAIM sensors. Several of these records contain large gaps. However, the GSLC group at POL has collected extensive sets of such ancillary data from meteorological agencies for its own analysis purposes, and should be able to provide further advice.

Deep Ocean Measurements

SSP measurements at deep ocean bottom pressure stations (together with inverted echo sounder and temperature measurements) have also been a feature of ACCLAIM. Measurements at Amsterdam and Kerguelen in the Indian Ocean are described in Vassie et al. (1994).

While most recording is now concentrated in the Scotia Sea - Drake Passage area of the Southern Ocean as part of WOCE Core 2. Tidal constituents from these recorders have contributed to the IAPSO Pelagic Constants data base maintained by the PSMSL at Bidston on behalf of IAPSO.

References

Spencer, R., Foden, P.R., McGarry, C., Harrison, A.J., Vassie, J.M., Baker, T.F., Smithson, M.J., Harangozo, S.A. and Woodworth, P.L. 1993.
The ACCLAIM programme in the South Atlantic and Southern Oceans. International Hydrographic Review, 70, 7-21.

Vassie, J.M., Harrison, A.J., Woodworth, P.L., Harangozo, S.A., Smithson, M.J. and Thompson, S.R. 1994.
On the temporal variability of the transport between Amsterdam and Kerguelen Islands. Journal of Geophysical Research, 99(C1), 937-949.

Woodworth, P.L., Vassie, J.M., Spencer, R. and Smith, D.E. 1996.
Precise datum control for pressure tide gauges. Marine Geodesy 19(1), 1-20.


World Ocean Circulation Experiment (WOCE)

The World Ocean Circulation Experiment (WOCE) was a major international experiment which made measurements and undertook modelling studies of the deep oceans in order to provide a much improved understanding of the role of ocean circulation in changing and ameliorating the Earth's climate.

WOCE had two major goals:

  • Goal 1. To develop models to predict climate and to collect the data necessary to test them.

  • Goal 2. To determine the representativeness of the Goal 1 observations and to deduce cost effective means of determining long-term changes in ocean circulation.


Data Activity or Cruise Information


No Data Activity or Cruise Information held for the Series


Fixed Station Information

Fixed Station Information

Station NameDrake Passage NNS/9596
CategoryOffshore location
Latitude56° 50.15' S
Longitude57° 30.09' W
Water depth below MSL2096.0 m

Drake Passage North North South NNS/9596 Site History

History Summary

Station Name NNS
Latitude 56° 50.15' S
Longitude 057° 30.09' W
Depth 2096 m
Units dbars
Sample Interval 15 minutes
Contributors Proudman Oceanographic Laboratory,
Joseph Proudman Building, Liverpool. U.K.
Instrument Type Paroscientific Digiquartz pressure transducer, with temperature recorded.
Period 26 Nov 1995 - 17 Nov 1996

Quality Assessment

Depth given is approximate, pressures are relative. Long-term drift has been satisfactorily removed from all data channels.


BODC Quality Control Flags

The following single character qualifying flags may be associated with one or more individual parameters with a data cycle:

Flag Description
Blank Unqualified
< Below detection limit
> In excess of quoted value
A Taxonomic flag for affinis (aff.)
B Beginning of CTD Down/Up Cast
C Taxonomic flag for confer (cf.)
D Thermometric depth
E End of CTD Down/Up Cast
G Non-taxonomic biological characteristic uncertainty
H Extrapolated value
I Taxonomic flag for single species (sp.)
K Improbable value - unknown quality control source
L Improbable value - originator's quality control
M Improbable value - BODC quality control
N Null value
O Improbable value - user quality control
P Trace/calm
Q Indeterminate
R Replacement value
S Estimated value
T Interpolated value
U Uncalibrated
W Control value
X Excessive difference

SeaDataNet Quality Control Flags

The following single character qualifying flags may be associated with one or more individual parameters with a data cycle:

Flag Description
0 no quality control
1 good value
2 probably good value
3 probably bad value
4 bad value
5 changed value
6 value below detection
7 value in excess
8 interpolated value
9 missing value
A value phenomenon uncertain
B nominal value
Q value below limit of quantification