Metadata Report for BODC Series Reference Number 1223139

• Metadata Summary

• Problem Reports

• Data Access Policy

• Narrative Documents

• Project Information

• Data Activity or Cruise Information

• Fixed Station Information

• BODC Quality Flags

• SeaDataNet Quality Flags

Metadata Summary

Problem Reports

No Problem Report Found in the Database

Data Access Policy

Open Data supplied by Natural Environment Research Council (NERC)

You must always use the following attribution statement to acknowledge the source of the information: "Contains data supplied by Natural Environment Research Council."

Narrative Documents

RD Instruments- Ocean Surveyor 150kHz Vessel mounted ADCP.

¹ Ranges at 1 to 5 knots ship speed are typical and vary with situation.
² Single-ping standard deviation.
³ User's choice of depth cell size is not limited to the typical values specified.

Profile Parameters

• Velocity long-term accuracy (typical): ±1.0%, ±0.5cm/s
• Velocity range: -5 to 9m/s
• # of depth cells: 1 - 128
• Max ping rate: 1.5

Bottom Track

Maximum altitude (precision <2cm/s): 600m

Echo Intensity Profile

Dynamic range: 80dB
Precision: ±1.5dB

Transducer & Hardware

Beam angle: 30°
Configuration: 4-beam phased array
Communications: RS-232 or RS-422 hex-ASCII or binary output at 1200 - 115,200 baud
Output power: 1000W

Standard Sensors

Temperature (mounted on transducer)

• Range: -5° to 45°C
• Precision: ±0.1°C
• Resolution: 0.03°

Environmental

Operating temperature: -5° to 40°C (-5° to 45°C)*
Storage temperature: -30° to 50°C (-30° to 60°C)*

*later instruments have greater range.

Web Page

Further details can be found in the manufacturer's website or in the specification sheet.

RAPID cruise D344 150kHz Shipboard ADCP data processing

Originator's processing

The following was taken from the D344 cruise report. For more detailed information please refer to Cunningham and Wright (2010).

The 150kHz ADCP is a narrow band phased array with a 30-degree beam angle. Data were acquired using RDI VmDas version 1.46 data acquisition software.

ADCP setup

The instrument was configured as follows

Operation

The OS150 was operated primarily in water track mode, aside from first and last couple of days when the vessel was operating in shallow water.

Calibration

The initial processing calculates statistics for evaluating the angle correction using bottom and/or water tracking. Plots are made of the u and v components, the percent good, and ship heading and speed for diagnostic purposes.

A time varying correction is applied to correct the more robust gyro heading for Schuler oscillations with the more accurate but less reliable ashtech heading.

After corrections applied, the calibrations are inspected again to determine the constant angle offset and scale factor to use for final processing. The final angle rotations were determined from when the ship steamed slowly over bathymetry on the south side of the North Providence Channel.

Shipboard thermosalinograph data are used to determine sound speed as these data are more accurate than the ADCP temperature data.

After the constant angle offset and scale factor are applied, they are re-calculated to verify that they are not statistically difference from zero.

References

Cunningham, S. A. and Wright, P. G. et al. RRS Discovery Cruise D344, 21 Oct - 18 Nov 2009. RAPID mooring cruise report. Southampton, UK: National Oceanography Centre, Southampton, 170pp. & 55 logsheets, National Oceanography Centre Cruise Report, No 51.

BODC processing

The data were converted from a Matlab format into BODC internal format, a netCDF subset, to allow use of in-house visualisation tools. The table below shows the mapping of originator variables to BODC Parameter codes.

Reformatted data were visually checked using the in-house editor EDSERPLO. No data values were edited or deleted. Flagging was achieved by modification of the associated quality control flag to 'M' for suspect values and 'N' for nulls.

Once quality control screening was complete, the data were archived in the BODC National Oceanographic Database and the associated metadata were loaded into an ORACLE Relational Database Management System.

Project Information

Monitoring the Meridional Overturning Circulation at 26.5N (RAPIDMOC)

Scientific Rationale

There is a northward transport of heat throughout the Atlantic, reaching a maximum of 1.3PW (25% of the global heat flux) around 24.5°N. The heat transport is a balance of the northward flux of a warm Gulf Stream, and a southward flux of cooler thermocline and cold North Atlantic Deep Water that is known as the meridional overturning circulation (MOC). As a consequence of the MOC northwest Europe enjoys a mild climate for its latitude: however abrupt rearrangement of the Atlantic Circulation has been shown in climate models and in palaeoclimate records to be responsible for a cooling of European climate of between 5-10°C. A principal objective of the RAPID programme is the development of a pre-operational prototype system that will continuously observe the strength and structure of the MOC. An initiative has been formed to fulfill this objective and consists of three interlinked projects:

• A mooring array spanning the Atlantic at 26.5°N to measure the southward branch of the MOC (Hirschi et al., 2003 and Baehr et al., 2004).
• Additional moorings deployed in the western boundary along 26.5°N (by Prof. Bill Johns, University of Miami) to resolve transport in the Deep Western Boundary Current (Bryden et al., 2005). These moorings allow surface-to-bottom density profiles along the western boundary, Mid-Atlantic Ridge, and eastern boundary to be observed. As a result, the transatlantic pressure gradient can be continuously measured.
• Monitoring of the northward branch of the MOC using submarine telephone cables in the Florida Straits (Baringer et al., 2001) led by Dr Molly Baringer (NOAA/AOML/PHOD).

The entire monitoring array system created by the three projects will be recovered and redeployed annually until 2008 under RAPID funding. From 2008 until 2014 the array will continue to be serviced annually under RAPID-WATCH funding.

The array will be focussed on three regions, the Eastern Boundary (EB), the Mid Atlantic Ridge (MAR) and the Western Boundary (WB). The geographical extent of these regions are as follows:

• Eastern Boundary (EB) array defined as a box with the south-east corner at 23.5°N, 25.5°W and the north-west corner at 29.0°N, 12.0°W
• Mid Atlantic Ridge (MAR) array defined as a box with the south-east corner at 23.0°N, 52.1°W and the north-west corner at 26.5°N, 40.0°W
• Western Boundary (WB) array defined as a box with the south-east corner at 26.0°N, 77.5°W and the north-west corner at 27.5°N, 69.5°W

References

Baehr, J., Hirschi, J., Beismann, J.O. and Marotzke, J. (2004) Monitoring the meridional overturning circulation in the North Atlantic: A model-based array design study. Journal of Marine Research, Volume 62, No 3, pp 283-312.

Baringer, M.O'N. and Larsen, J.C. (2001) Sixteen years of Florida Current transport at 27N Geophysical Research Letters, Volume 28, No 16, pp3179-3182

Bryden, H.L., Johns, W.E. and Saunders, P.M. (2005) Deep Western Boundary Current East of Abaco: Mean structure and transport. Journal of Marine Research, Volume 63, No 1, pp 35-57.

Hirschi, J., Baehr, J., Marotzke J., Stark J., Cunningham S.A. and Beismann J.O. (2003) A monitoring design for the Atlantic meridional overturning circulation. Geophysical Research Letters, Volume 30, No 7, article number 1413 (DOI 10.1029/2002GL016776)

RAPID- Will the Atlantic Thermohaline Circulation Halt? (RAPID-WATCH)

RAPID-WATCH (2007-2014) is a continuation programme of the Natural Environment Research Council's (NERC) Rapid Climate Change (RAPID) programme. It aims to deliver a robust and scientifically credible assessment of the risk to the climate of UK and Europe arising from a rapid change in the Atlantic Meridional Overturning Circulation (MOC). The programme will also assess the need for a long-term observing system that could detect major MOC changes, narrow uncertainty in projections of future change, and possibly be the start of an 'early warning' prediction system.

The effort to design a system to continuously monitor the strength and structure of the North Atlantic MOC is being matched by comparative funding from the US National Science Foundation (NSF) for the existing collaborations started during RAPID for the observational arrays.

Scientific Objectives

• To deliver a decade-long time series (2004-2014) of calibrated and quality-controlled measurements of the Atlantic MOC from the RAPID-WATCH arrays.
• To exploit the data from the RAPID-WATCH arrays and elsewhere to determine and interpret recent changes in the Atlantic MOC, assess the risk of rapid climate change, and investigate the potential for predictions of the MOC and its impacts on climate.

This work will be carried out in collaboration with the Hadley Centre in the UK and through international partnerships.

Mooring Arrays

The RAPID-WATCH arrays are the existing 26°N MOC observing system array (RAPIDMOC) and the WAVE array that monitors the Deep Western Boundary Current. The data from these arrays will work towards meeting the first scientific objective.

The RAPIDMOC array consists of moorings focused in three geographical regions (sub-arrays) along 26.5° N: Eastern Boundary, Mid-Atlantic Ridge and Western Boundary. The Western Boundary sub-array has moorings managed by both the UK and US scientists. The other sub-arrays are solely led by the UK scientists. The lead PI is Dr Stuart Cunningham of the National Oceanography Centre, Southampton, UK.

The WAVE array consists of one line of moorings off Halifax, Nova Scotia. The line will be serviced in partnership with the Bedford Institute of Oceanography (BIO), Halifax, Canada. The lead PI is Dr Chris Hughes of the Proudman Oceanographic Laboratory, Liverpool, UK.

All arrays will be serviced (recovered and redeployed) either on an annual or biennial basis using Research Vessels from the UK, US and Canada.

Modelling Projects

The second scientific objective will be addressed through numerical modelling studies designed to answer four questions:

• How can we exploit data from the RAPID-WATCH arrays to obtain estimates of the MOC and related variables?
• What do the observations from the RAPID-WATCH arrays and other sources tell us about the nature and causes of recent changes in the Atlantic Ocean?
• What are the implications of RAPID-WATCH array data and other recent observations for estimates of the risk due to rapid change in the MOC?
• Could we use RAPID-WATCH and other observations to help predict future changes in the MOC and climate?

Data Activity or Cruise Information

Cruise

Complete Cruise Metadata Report is available here

Fixed Station Information

No Fixed Station Information held for the Series

BODC Quality Control Flags

The following single character qualifying flags may be associated with one or more individual parameters with a data cycle:

SeaDataNet Quality Control Flags

The following single character qualifying flags may be associated with one or more individual parameters with a data cycle: