Metadata Report for BODC Series Reference Number 541742

• Metadata Summary

• Problem Reports

• Data Access Policy

• Narrative Documents

• Project Information

• Data Activity or Cruise Information

• Fixed Station Information

• BODC Quality Flags

• SeaDataNet Quality Flags

Metadata Summary

Problem Reports

No Problem Report Found in the Database

Data Access Policy

Open Data supplied by Natural Environment Research Council (NERC)

You must always use the following attribution statement to acknowledge the source of the information: "Contains data supplied by Natural Environment Research Council."

Narrative Documents

Aanderaa Thermistor Conductivity Chain

Description

The Aanderaa Conductivity Temperature Recorder CTR 7 consists of a 12- channel datalogger (DL7) and a string of up to 5 C/T sensors (series 3211). The sensors are clamped to the sensor string (series 3258) by a fastening fixture. The C/T sensors are of the electrodeless induction type based on two toroid windings surrounding a calibrated bore. The temperature is measured by a thermistor. One of the C/T can be replaced by a C/T/D sensor if required.

Specifications for CTR7

Datalogger DL7

C/T sensor 3211

Conductivity Temperature

Mooring and Data Processing Notes

Mooring Configuration

The datalogger was deployed at a depth of 14 m at the end of a 10 m cable length on which the five C/T sensors were clamped. The depth of the five C/T sensors was 13.05, 10.55, 8.05, 5.55 and 3.05 metres respectively. A pressure sensor was located 0.55 metre above the last C/T sensor. Pressure was logged on channel 11 of the datalogger.

Data Processing

Salinity was calculated from conductivity, temperature and pressure using the pre-78 formula as outlined in UNESCO (1966), Bennett A.S. (1976, Deep Sea Research 23:157-165), and Dauphinee T.M. and Klein H.P. (1977, Deep Sea Research 24:891-902).

General Data Screening carried out by BODC

BODC screen both the series header qualifying information and the parameter values in the data cycles themselves.

Header information is inspected for:

• Irregularities such as unfeasible values
• Inconsistencies between related information, for example:
  • Times for instrument deployment and for start/end of data series
  • Length of record and the number of data cycles/cycle interval
  • Parameters expected and the parameters actually present in the data cycles
• Originator's comments on meter/mooring performance and data quality

Documents are written by BODC highlighting irregularities which cannot be resolved.

Data cycles are inspected using time or depth series plots of all parameters. Currents are additionally inspected using vector scatter plots and time series plots of North and East velocity components. These presentations undergo intrinsic and extrinsic screening to detect infeasible values within the data cycles themselves and inconsistencies as seen when comparing characteristics of adjacent data sets displaced with respect to depth, position or time. Values suspected of being of non-oceanographic origin may be tagged with the BODC flag denoting suspect value; the data values will not be altered.

The following types of irregularity, each relying on visual detection in the plot, are amongst those which may be flagged as suspect:

• Spurious data at the start or end of the record.
• Obvious spikes occurring in periods free from meteorological disturbance.
• A sequence of constant values in consecutive data cycles.

If a large percentage of the data is affected by irregularities then a Problem Report will be written rather than flagging the individual suspect values. Problem Reports are also used to highlight irregularities seen in the graphical data presentations.

Inconsistencies between the characteristics of the data set and those of its neighbours are sought and, where necessary, documented. This covers inconsistencies such as the following:

• Maximum and minimum values of parameters (spikes excluded).
• The occurrence of meteorological events.

This intrinsic and extrinsic screening of the parameter values seeks to confirm the qualifying information and the source laboratory's comments on the series. In screening and collating information, every care is taken to ensure that errors of BODC making are not introduced.

Project Information

PROcesses of Vertical Exchange in Shelf Seas (PROVESS)

Introduction

PROVESS was an interdisciplinary study of the vertical fluxes of properties through the water column and the surface and bottom boundary layers. The project was funded by the European Community MAST-III programme (MAS3-CT97- 0159) and ran from March 1998 to May 2001.

Scientific Rationale

PROVESS was based on the integration of experimental, theoretical and modelling studies with the aim of improving understanding and quantification of vertical exchange processes in the water column, in particular in the surface and benthic boundary layers and across the> pycnocline. PROVESS also explored mechanisms of physical-biological coupling in which vertical exchanges and turbulence significantly affect the environmental conditions experienced by the biota with particular reference to aggregation, flocculation, sedimentation and trophic interactions.

Fieldwork

The experimental phase of the project was carried out at two contrasting sites in the North Sea: the northern North Sea site (NNS) and the southern North Sea site (SNS).

The two sites had the following characteristics:

At both locations measurements were concentrated at a central position with additional measurements being made to estimate horizontal gradients. Moored instruments (including current meters, temperature and pressure sensors, fluorometers, transmissometers, nutrient analysers and meteorological sensors) were deployed between 7 September and 5 November 1998 at the NNS and between 29 March and 25 May 1999 at the SNS. Each experiment was supported by intensive measurement series made from oceanographic ships and involving turbulence dissipation profiler CTD, particle size profilers, optical profilers, benthic sampling and water bottle sampling.

Details of the cruises were as follows:

Data Activity or Cruise Information

Data Activity

PROVESS Project POLRIG#825

This mooring was known within PROVESS as 'Rig T'. It was deployed on the western leg of the Southern North Sea Site during the spring of 1999.

Related Data Activity activities are detailed in Appendix 1

Cruise

Complete Cruise Metadata Report is available here

Fixed Station Information

Fixed Station Information

PROVESS Southern North Sea Site

Eleven mooring packages were deployed at PROVESS Southern North Sea site by Pelagia cruise PE136 in March 1999. One of these (Rig U) was lost, the NIOZ mooring was recovered by PE136 in April 1999 and the remaining nine were recovered by either RV Belgica cruise BG9912 (8 moorings) or RV Zirfea (Rig V) in May 1999.

The layout of the mooring array was:

The asterisk represents an array of five moorings as detailed in the inset map.

Mooring data

The data returned from each rig were as follows:

CTD data

A total of 356 CTD casts were also collected during the three cruises surveying this area. These include:

Additonal data

Supporting meteorological data (including sea surface temperature and wave statistics) from two platforms (52° 33' N, 4° 3.5' E and 52° 16.4' N, 4° 17.8' E) were supplied to the project and are held by BODC. These series run from the beginning of March 1999 until the end of May 1999.

Related Fixed Station activities are detailed in Appendix 2

BODC Quality Control Flags

The following single character qualifying flags may be associated with one or more individual parameters with a data cycle:

SeaDataNet Quality Control Flags

The following single character qualifying flags may be associated with one or more individual parameters with a data cycle:

Appendix 1: POLRIG#825

Related series for this Data Activity are presented in the table below. Further information can be found by following the appropriate links.

If you are interested in these series, please be aware we offer a multiple file download service. Should your credentials be insufficient for automatic download, the service also offers a referral to our Enquiries Officer who may be able to negotiate access.

Appendix 2: PROVESS Southern North Sea Site

Related series for this Fixed Station are presented in the table below. Further information can be found by following the appropriate links.

If you are interested in these series, please be aware we offer a multiple file download service. Should your credentials be insufficient for automatic download, the service also offers a referral to our Enquiries Officer who may be able to negotiate access.